This semiconductor gas sensor detects the presence of Carbon Monoxide at concentrations from 10 to 10,000 ppm. The sensor’s simple analog voltage interface requires only one analog input pin from your microcontroller.
Overview
This Carbon Monoxide (CO) gas sensor detects the concentrations of CO in the air and ouputs its reading as an analog voltage. The sensor can measure concentrations of 10 to 10,000ppm.The sensor can operate at temperatures from -10 to 50°C and consumes less than 150mA at 5V. Please read the MQ7 datasheet (54k pdf) for more information about the sensor.
 |
| Gas sensor with orange plastic case bottom view. |
Connections
Connecting five volts across the heating (H) pins keeps the sensor hot enough to function correctly. Connecting five volts at either the A or B pins causes the sensor to emit an analog voltage on the other pins. A resistive load between the output pins and ground sets the sensitivity of the detector. The resistive load should be calibrated for your particular application using the equations in the datasheet, but a good starting value for the resistor is 10kΩ.
We offer two breakout boards that make it easier to interface with these sensors: a Pololu carrier board and a SparkFun carrier board. The Pololu version is shown below.
 |
| Pololu MQ gas sensor carrier with sensitivity-setting resistor soldered in the vertical orientation. |
|
No recommended products at the moment.
No recommended products at the moment.
